Simultaneous wireless information and power transfer (SWIPT) has been proposed to offer communication services and transfer power to the energy harvesting receiver (EHR) concurrently. However, existing works mainly focused on static EHRs, without considering the location uncertainty caused by the movement of EHRs and location estimation errors. To tackle this issue, this paper considers the sensing-assisted SWIPT design in a networked integrated sensing and communication (ISAC) system in the presence of location uncertainty. A two-phase robust design is proposed to reduce the location uncertainty and improve the power transfer efficiency. In particular, each time frame is divided into two phases, i.e., sensing and WPT phases, via time-splitting. The sensing phase performs collaborative sensing to localize the EHR, whose results are then utilized in the WPT phase for efficient WPT. To minimize the power consumption with given communication and power transfer requirements, a two-layer optimization framework is proposed to jointly optimize the time-splitting ratio, coordinated beamforming policy, and sensing node selection. Simulation results validate the effectiveness of the proposed design and demonstrate the existence of an optimal time-splitting ratio for given location uncertainty.
Future wireless networks are envisioned to simultaneously provide high data-rate communication and ubiquitous environment-aware services for numerous users. One promising approach to meet this demand is to employ network-level integrated sensing and communications (ISAC) by jointly designing the signal processing and resource allocation over the entire network. However, to unleash the full potential of network-level ISAC, some critical challenges must be tackled. Among them, interference management is one of the most significant ones. In this article, we build up a bridge between interference mitigation techniques and the corresponding optimization methods, which facilitates efficient interference mitigation in network-level ISAC systems. In particular, we first identify several types of interference in network-level ISAC systems, including self-interference, mutual interference, crosstalk, clutter, and multiuser interference. Then, we present several promising techniques that can be utilized to suppress specific types of interference. For each type of interference, we discuss the corresponding problem formulation and identify the associated optimization methods. Moreover, to illustrate the effectiveness of the proposed interference mitigation techniques, two concrete network-level ISAC systems, namely coordinated cellular network-based and distributed antenna-based ISAC systems, are investigated from interference management perspective. Experiment results indicate that it is beneficial to collaboratively employ different interference mitigation techniques and leverage the network structure to achieve the full potential of network-level ISAC. Finally, we highlight several promising future research directions for the design of ISAC systems.
Movable antennas (MAs) are a promising paradigm to enhance the spatial degrees of freedom of conventional multi-antenna systems by flexibly adapting the positions of the antenna elements within a given transmit area. In this paper, we model the motion of the MA elements as discrete movements and study the corresponding resource allocation problem for MA-enabled multiuser multiple-input single-output (MISO) communication systems. Specifically, we jointly optimize the beamforming and the MA positions at the base station (BS) for the minimization of the total transmit power while guaranteeing the minimum required signal-to-interference-plus-noise ratio (SINR) of each individual user. To obtain the globally optimal solution to the formulated resource allocation problem, we develop an iterative algorithm capitalizing on the generalized Bender's decomposition with guaranteed convergence. Our numerical results demonstrate that the proposed MA-enabled communication system can significantly reduce the BS transmit power and the number of antenna elements needed to achieve a desired performance compared to state-of-the-art techniques, such as antenna selection. Furthermore, we observe that refining the step size of the MA motion driver improves performance at the expense of a higher computational complexity.
Different from conventional radar, the cellular network in the integrated sensing and communication (ISAC) system enables collaborative sensing by multiple sensing nodes, e.g., base stations (BSs). However, existing works normally assume designated BSs as the sensing nodes, and thus can't fully exploit the macro-diversity gain. In the paper, we propose a joint BS selection, user association, and beamforming design to tackle this problem. The total transmit power is minimized while guaranteeing the communication and sensing performance measured by the signal-to-interference-plus-noise ratio (SINR) for the communication users and the Cramer-Rao lower bound (CRLB) for location estimation, respectively. An alternating optimization (AO)-based algorithm is developed to solve the non-convex problem. Simulation results validate the effectiveness of the proposed algorithm and unveil the benefits brought by collaborative sensing and BS selection.
Integrated sensing and communication (ISAC) has recently merged as a promising technique to provide sensing services in future wireless networks. In the literature, numerous works have adopted a monostatic radar architecture to realize ISAC, i.e., employing the same base station (BS) to transmit the ISAC signal and receive the echo. Yet, the concurrent information transmission causes severe self-interference (SI) to the radar echo at the BS which cannot be effectively suppressed. To overcome this difficulty, in this paper, we propose a coordinated cellular network-supported multistatic radar architecture to implement ISAC. In particular, among all the coordinated BSs, we select a BS as the multistatic receiver to receive the sensing echo signal, while the other BSs act as the multistatic transmitters to collaborate with each other to facilitate cooperative ISAC. This allows us to spatially separate the ISAC signal transmission and radar echo reception, intrinsically circumventing the problem of SI. To this end, we jointly optimize the transmit and receive beamforming policy to minimize the sensing beam pattern mismatch error subject to both the communication and sensing quality-of-service requirements. The resulting non-convex optimization problem is tackled by a low-complexity alternating optimization-based suboptimal algorithm. Simulation results showed that the proposed scheme outperforms the two baseline schemes adopting conventional designs. Moreover, our results confirm that the proposed architecture is promising in achieving high-quality ISAC.
In this paper, we investigate joint resource allocation and trajectory design for multi-user multi-target unmanned aerial vehicle (UAV)-enabled integrated sensing and communication (ISAC). To improve sensing accuracy, the UAV is forced to hover during sensing.~In particular, we jointly optimize the two-dimensional trajectory, velocity, downlink information and sensing beamformers, and sensing indicator to minimize the average power consumption of a fixed-altitude UAV, while considering the quality of service of the communication users and the sensing tasks. To tackle the resulting non-convex mixed integer non-linear program (MINLP), we exploit semidefinite relaxation, the big-M method, and successive convex approximation to develop an alternating optimization-based algorithm.~Our simulation results demonstrate the significant power savings enabled by the proposed scheme compared to two baseline schemes employing heuristic trajectories.
Active reconfigurable intelligent surfaces (RISs) have recently been proposed to compensate for the severe multiplicative fading effect of conventional passive RIS-aided systems. Each reflecting element of active RISs is assisted by an amplifier such that the incident signal can be reflected and amplified instead of only being reflected as in passive RIS-aided systems. This work addresses the practical challenge that, on the one hand, in active RIS-aided systems the perfect individual CSI of the RIS-aided channels cannot be acquired due to the lack of signal processing power at the active RISs, but, on the other hand, this CSI is required to calculate the expected system data rate and RIS transmit power needed for transceiver design. To address this issue, we first derive closed-form expressions for the average achievable rate and the average RIS transmit power based on partial CSI of the RIS-aided channels. Then, we formulate an average achievable rate maximization problem for jointly optimizing the active beamforming at both the base station (BS) and the RIS. This problem is then tackled using the majorization--minimization (MM) algorithm framework, and, for each iteration, semi-closed-form solutions for the BS and RIS beamforming are derived based on the Karush-Kuhn-Tucker (KKT) conditions. To ensure the quality of service (QoS) of each user, we further formulate a rate outage constrained beamforming problem, which is solved using the Bernstein-Type inequality (BTI) and semidefinite relaxation (SDR) techniques. Numerical results show that the proposed algorithms can efficiently overcome the challenges imposed by imperfect CSI in active RIS-aided wireless systems.
In this paper, we investigate the resource allocation design for integrated sensing and communication (ISAC) in distributed antenna networks (DANs). In particular, coordinated by a central processor (CP), a set of remote radio heads (RRHs) provide communication services to multiple users and sense several target locations within an ISAC frame. To avoid the severe interference between the information transmission and the radar echo, we propose to divide the ISAC frame into a communication phase and a sensing phase. During the communication phase, the data signal is generated at the CP and then conveyed to the RRHs via fronthaul links. As for the sensing phase, based on pre-determined RRH-target pairings, each RRH senses a dedicated target location with a synthesized highly-directional beam and then transfers the samples of the received echo to the CP via its fronthaul link for further processing of the sensing information. Taking into account the limited fronthaul capacity and the quality-of-service requirements of both communication and sensing, we jointly optimize the durations of the two phases, the information beamforming, and the covariance matrix of the sensing signal for minimization of the total energy consumption over a given finite time horizon. To solve the formulated non-convex design problem, we develop a low-complexity alternating optimization algorithm which converges to a suboptimal solution. Simulation results show that the proposed scheme achieves significant energy savings compared to two baseline schemes. Moreover, our results reveal that for efficient ISAC in wireless networks, energy-focused short-duration pulses are favorable for sensing while low-power long-duration signals are preferable for communication.
Automatically summarizing patients' main problems from daily progress notes using natural language processing methods helps to battle against information and cognitive overload in hospital settings and potentially assists providers with computerized diagnostic decision support. Problem list summarization requires a model to understand, abstract, and generate clinical documentation. In this work, we propose a new NLP task that aims to generate a list of problems in a patient's daily care plan using input from the provider's progress notes during hospitalization. We investigate the performance of T5 and BART, two state-of-the-art seq2seq transformer architectures, in solving this problem. We provide a corpus built on top of progress notes from publicly available electronic health record progress notes in the Medical Information Mart for Intensive Care (MIMIC)-III. T5 and BART are trained on general domain text, and we experiment with a data augmentation method and a domain adaptation pre-training method to increase exposure to medical vocabulary and knowledge. Evaluation methods include ROUGE, BERTScore, cosine similarity on sentence embedding, and F-score on medical concepts. Results show that T5 with domain adaptive pre-training achieves significant performance gains compared to a rule-based system and general domain pre-trained language models, indicating a promising direction for tackling the problem summarization task.
In this paper, we investigate the robust resource allocation design for secure communication in an integrated sensing and communication (ISAC) system. A multi-antenna dual-functional radar-communication (DFRC) base station (BS) serves multiple single-antenna legitimate users and senses for targets simultaneously, where already identified targets are treated as potential single-antenna eavesdroppers. The DFRC BS scans a sector with a sequence of dedicated beams, and the ISAC system takes a snapshot of the environment during the transmission of each beam. Based on the sensing information, the DFRC BS can acquire the channel state information (CSI) of the potential eavesdroppers. Different from existing works that focused on the resource allocation design for a single snapshot, in this paper, we propose a novel optimization framework that jointly optimizes the communication and sensing resources over a sequence of snapshots with adjustable durations. To this end, we jointly optimize the duration of each snapshot, the beamforming vector, and the covariance matrix of the AN for maximization of the system sum secrecy rate over a sequence of snapshots while guaranteeing a minimum required average achievable rate and a maximum information leakage constraint for each legitimate user. The resource allocation algorithm design is formulated as a non-convex optimization problem, where we account for the imperfect CSI of both the legitimate users and the potential eavesdroppers. To make the problem tractable, we derive a bound for the uncertainty region of the potential eavesdroppers' small-scale fading based on a safe approximation, which facilitates the development of a block coordinate descent-based iterative algorithm for obtaining an efficient suboptimal solution.