Directional Measurements and Analysis for FR3 Low-Altitude Channels in a Campus Environment

In this paper, we present detailed low-altitude channel measurements at the FR3 band in an outdoor campus environment. Using a time-domain channel sounder system, we conduct two types of measurements: path loss measurements by moving the transmitter (Tx) at one-meter intervals along a 26-point rooftop path, and directional power angular spectrum measurements through antenna scanning at half-power beam width intervals. The path loss analysis across different Rx shows that the close-in model outperforms conventional 3GPP models and height-corrected variants, with path loss exponents close to free space values indicating line-of-sight dominance. The power angular spectrum measurements show that propagation behavior varies significantly with environmental conditions. Closer Rx exhibit stronger sensitivity to ground reflections during downward Tx tilting, while obstructed links display uniform angular characteristics due to dominant scattering effects, and corridor environments produce asymmetric power distributions. These results indicate that low-altitude propagation is characterized by complex interactions between Tx height and ground scattering mechanisms, providing fundamental insights for channel modeling in emerging mid-band communication systems.

Millimeter-Wave Energy-Efficient Hybrid Beamforming Architecture and Algorithm

This paper studies energy-efficient hybrid beamforming architectures and its algorithm design in millimeter-wave communication systems, aiming to address the challenges faced by existing hybrid beamforming due to low hardware flexibility and high power consumption. To solve the problems of existing hybrid beamforming, a novel energy-efficient hybrid beamforming architecture is proposed, where radio-frequency (RF) switch networks are introduced at the front and rear ends of the phase shifter network, enabling dynamic connections between the RF chains and the phase shifter array as well as the antenna array. The system model of the proposed architecture is established, including digital precoding and analog precoding processes, and the practical hardware limitations such as quantization errors of the digital-to-analog converter (DAC) and phase shifter resolution. In order to maximize the energy efficiency, this paper derives an energy efficiency model including spectral efficiency and system power consumption, and a hybrid precoding algorithm is proposed based on block coordinate descent to iteratively optimize the digital precoding matrix, analog precoding matrix, and DAC resolution. Simulation results under the NYUSIM-generated millimeter-wave channels show that the proposed hybrid beamforming architecture and precoding algorithm have higher energy efficiency than existing representative architectures and precoding algorithms under complete and partial channel state information, while the loss of spectral efficiency compared to fully connected architecture is less than 20%