Long-Range Backscatter: A Bottom-Up Approach

Continued progress towards energy-neutral Internet of Things (IoT) nodes expose the wireless communication link as the dominant energy bottleneck. While low-power wide-area network (LPWAN) technologies achieve long-range communication with multiple years of battery life, their active radios hinder reaching full energy neutrality. Long-range backscatter communication emerged as a key enabler, reaching one to three order of magnitude lower power consumption. New advancements leverage concepts from active radio systems such as chirp spread spectrum (CSS) modulation and integrate them on a low-power backscatter tag. This paper presents a comprehensive survey of long-range backscatter communication, using a bottom-up analysis spanning system topologies, hardware architecture, modulation techniques and medium access. Backscatter communication requires different topologies compared to active radios to reach longer communication distances. Different hardware architectures support backscattering a modulated signal with differing complexity, power consumption and spectral efficiency. At the physical layer binary switch-based modulation are well known and provide an easy form of modulation while chirp spread spectrum (CSS)-based modulation gain traction due to their robustness. Medium Access Control (MAC) techniques are examined with a focus on synchronization, concurrency and lightweight feedback mechanisms requiring low-power, low-complexity hardware. Building on these established solutions the paper evaluates the feasibility of long-range backscatter communication in different energy-neutral Internet of Things (IoT) applications. Starting from the available energy budget, harvested through solar, radio frequency (RF) or capacitive harvesting, feasible hardware, modulation and Medium Access Control (MAC) solutions are explored.

An Open-Source Hardware-Aware Sub-THz Radio-Stripe Simulator

Sub-Terahertz radio-stripe and distributed MIMO architectures promise extreme spatial reuse and multi-GHz bandwidths, but the cascaded fiber front-haul and RF hardware impairments strongly shape end-to-end performance. This paper presents an open-source, configuration-driven simulator that models the full waveform-level signal chain from CP-OFDM baseband generation in the central unit, through measurement-parameterized polymer microwave fiber and coupler links, to booster/active Radio Units (RUs) with configurable nonlinearity, noise, in-phase and quadrature imbalance, and oscillator phase noise and carrier frequency offset. Wireless propagation is supported via lightweight deterministic and stochastic per-subcarrier channel models as well as site-specific ray-tracing datasets generated with a companion Sionna ray-tracer module. The simulator exports intermediate waveforms and system metrics (e.g., normalised mean square error, signal-to-noise-and-distortion ratio, bit error rate) to enable reproducible studies of impairment accumulation, calibration, and algorithmic choices such as RU selection and beam management.