Real-time Estimator of Actuator Control and Health (REACH) on an Eel-Inspired Soft Robot

An actuator health estimation algorithm for a soft swimming robot that can perform anguilliform swimming is developed. Due to harsh operational environments of underwater robots, and the common degradation of soft robot materials and actuators, accurate estimation of actuator functionality is necessary for robots to perform their missions as well as return to base in the event of actuator degradation and failure. Termed REACH (Real-time Estimator of Actuator Control and Health), the architecture employs a soft robot model, sigma point filter, and a formal statistical hypothesis test to adequately capture the nonlinearities and changes over time. The performance of REACH using three sensor types (GPS, IMU, and Bend Sensor) with one sensor on each actuator is compared, demonstrating that both bend sensor and IMU are adequate choices. Sensor quantity and placement are evaluated for IMU and bend sensor, showing two sensors are sufficient for IMU, whereas three sensors are needed for bend sensor. Three swimming gaits (linear swimming, wide turning, tight turning) are compared, demonstrating that REACH can successfully predict actuator health for all three gaits, with minimal differences in performance. A filter validation method shows the fault estimation algorithm is statistically consistent in finding the correct degradation. The approach is experimentally evaluated using bend sensor data collected from a fish robot, demonstrating that REACH can successfully estimate actuator health with noisy data and variations in manufacturing.

Modeling and Control of an Eel-Inspired Soft Robot for Design Optimization

Anguilliform locomotion is a highly efficient swimming mode; the advent of new materials for soft robots enables the development of an eel-inspired soft robot. This paper presents a simulation model of an eel-inspired soft robot designed for anguilliform swimming. This model can aid in design optimization and the development of model-based estimation, reasoning, and control systems. A Finite Element Method (FEM) model of an elastic rod is used to capture the soft materials of the robotic fish, which makes it particularly amenable to variation over time as the material properties change. The material model is coupled with a hydrodynamic force model to simulate the behavior of a soft, elongated robot in water. The model is used to demonstrate the effectiveness of the proposed control approaches in achieving desired swimming behaviors. It also provides insights into design decisions, including the robustness of different system configurations and the impact of material degradation and failure. The results show that slightly asymmetric designs are advantageous, offering comparable swimming velocities but greater maneuverability. This model can be used to guide future robotic design decisions aimed at optimizing performance for specific tasks.