Operational Modal Analysis of Aeronautical Structures via Tangential Interpolation

Over the last decades, progress in modal analysis has enabled increasingly routine use of modal parameters, including those extracted from in-situ measurements, for applications such as structural health monitoring and finite element model updating. For output-only identification, or Operational Modal Analysis (OMA), widely adopted approaches include Stochastic Subspace Identification (SSI) methods and the Natural Excitation Technique combined with the Eigensystem Realization Algorithm (NExT-ERA). Nevertheless, SSI-based techniques may become cumbersome on large systems, while NExT-ERA fitting can struggle when measurements are contaminated by noise. To alleviate these, this work investigates an OMA frequency-domain formulation for aeronautical structures by coupling the Loewner Framework (LF) with NExT, yielding the proposed NExT-LF method. The method exploits the computational efficiency of LF together with the impulse response function retrieval enabled by NExT. NExT-LF is assessed on two experimental benchmarks: the eXperimental BeaRDS 2 high-aspect-ratio wing main spar and an Airbus Helicopters H135 bearingless main rotor blade. The identified modal parameters are compared against available experimental references and results obtained via SSI with Canonical Variate Analysis and NExT-ERA. The results show that the modes identified by NExT-LF correlate well with benchmark data, particularly for high-amplitude tests and in the low-frequency range.

Affordable Data Collection System for UAVs Taxi Vibration Testing

Structural vibration testing plays a key role in aerospace engineering for evaluating dynamic behaviour, ensuring reliability and verifying structural integrity. These tests rely on accurate and robust data acquisition systems (DAQ) to capture high-quality acceleration data. However, commercial DAQs that provide the required performance and features are often expensive and complex, limiting their accessibility for small-scale research and experimental applications. This work presents the design and experimental validation of an affordable and in-house-developed acceleration DAQ, tested on a small fixed-wing UAV through several Taxi Vibration Test (TVT) runs and ambient vibration measurements. The proposed system integrates several OrangePi 3 LTS single-board computers with multiple LSM6DS3TR-C MEMS inertial measurement units operating simultaneously via an Inter-Integrated Circuit (I2C) communication interface, managed under a Python-based master/slave architecture. Data is acquired at a stable sampling rate of approximately 208 Hz and post-processed using Welch's method to estimate their Power Spectral Density (PSD). Results confirm the system ability to provide consistent multi-sensor acceleration data and repeatable PSD profiles under the same test conditions; thus, demonstrating its reliability. With a total hardware cost below 600 EUR (approximately 690 USD), the developed DAQ offers a compact, scalable and cost-effective alternative for aerospace vibration analysis and structural testing.