Active Reconfigurable Intelligent Surfaces for the Millimeter-Wave Frequency Band: System Design and Measurement

Reconfigurable intelligent surfaces (RISs) will play a key role to establish millimeter wave (mmWave) ultra-reliable low-latency communication systems for sixth-generation (6G) applications. Currently, there are a few working prototypes of RISs operating in the mmWave frequency band and all of them are based on passive reflective elements. However, to fabricate an efficiently working RIS at mmWave frequencies, it is crucial to take care of the strong signal attenuation, reflective element losses and undesired radio frequency (RF) circuit effects. In this paper, we provide measurement campaign results for an active RIS in the mmWave frequency band as well as its analysis and system design. The obtained results demonstrate that an active RIS outperforms a RIS working in passive mode and provides a higher signal-to-noise-ratio (SNR). The active RIS consists of active reflective elements that amplify the impinging signal and reflect the signal to the desired beam direction. To obtain an efficient RIS in terms of power consumption and RIS state switch time, we design a hexagonal RIS with 37 elements working at 26 GHz. These elements are designed to work whether in passive state (binary phase shifting) or in active state (switch OFF or amplifying). We provide a comparison between the performance of a RIS working in passive and active mode using numerical simulations and empirical measurements. This comparison reveals that the active reflective intelligent surface (RIS) provides a received power that is at least 4 dB higher than that of the equivalent passive RIS. These results demonstrate the strong advantage of using active RISs for future ultra-reliable low-latency wireless communications.