Coordinated motion control of a wire arc additive manufacturing robotic system for multi-directional building parts

This work investigates the manufacturing of complex shapes parts with wire arc additive manufacturing (WAAM). In order to guarantee the integrity and quality of each deposited layer that composes the final piece, the deposition process is usually carried out in a flat position. However, for complex geometry parts with non-flat surfaces, this strategy causes unsupported overhangs and staircase effect, which contribute to a poor surface finishing. Generally, the build direction is not constant for every deposited section or layer in complex geometry parts. As a result, there is an additional concern to ensure the build direction is aligned with gravity, thus improving the quality of the final part. This paper proposes an algorithm to control the torch motion with respect to a deposition substrate as well as the torch orientation with respect to an inertial frame. The control scheme is based on task augmentation applied to an extended kinematic chain composed by two robots, which constitutes a coordinated control problem, and allows the deposition trajectory to be planned with respect to the deposition substrate coordinate frame while aligning each layer buildup direction with gravity (or any other direction defined for an inertial frame). Parts with complex geometry aspects have been produced in a WAAM cell composed by two robots (a manipulator with a welding torch and a positioning table holding the workpiece) in order to validate the proposed approach.

Multi-DoF Time Domain Passivity Approach Based Drift Compensation for Telemanipulation

When, in addition to stability, position synchronization is also desired in bilateral teleoperation, Time Domain Passivity Approach (TDPA) alone might not be able to fulfill the desired objective. This is due to an undesired effect caused by admittance type passivity controllers, namely position drift. Previous works focused on developing TDPA-based drift compensation methods to solve this issue. It was shown that, in addition to reducing drift, one of the proposed methods was able to keep the force signals within their normal range, guaranteeing the safety of the task. However, no multi-DoF treatment of those approaches has been addressed. In that scope, this paper focuses on providing an extension of previous TDPA-based approaches to multi-DoF Cartesian-space teleoperation. An analysis of the convergence properties of the presented method is also provided. In addition, its applicability to multi-DoF devices is shown through hardware experiments and numerical simulation with round-trip time delays up to 700 ms.