Online Thermal Field Prediction for Metal Additive Manufacturing of Thin Walls

This paper aims to study a practical issue in metal AM, i.e., how to predict the thermal field of yet-to-print parts online when only a few sensors are available. This work proposes an online thermal field prediction method using mapping and reconstruction, which could be integrated into a metal AM process for online performance control. Based on the similarity of temperature curves (curve segments of a temperature profile of one point), the thermal field mapping applies an artificial neural network to estimate the temperature curves of points on the yet-to-print layer from measured temperatures of certain points on the previously printed layer. With measured/predicted temperature profiles of several points on the same layer, the thermal field reconstruction proposes a reduced order model (ROM) to construct the temperature profiles of all points on the same layer, which could be used to build the temperature field of the entire layer. The training of ROM is performed with an extreme learning machine (ELM) for computational efficiency. Fifteen wire arc AM experiments and nine simulations are designed for thin walls with a fixed length and unidirectional printing of each layer. The test results indicate that the proposed prediction method could construct the thermal field of a yet-to-print layer within 0.1 seconds on a low-cost desktop. Meanwhile, the method has acceptable generalization capability in most cases from lower layers to higher layers in the same simulation and from one simulation to a new simulation on different AM process parameters. More importantly, after fine-tuning the proposed method with limited experimental data, the relative errors of all predicted temperature profiles on a new experiment are sufficiently small, demonstrating the applicability and generalization of the proposed thermal field prediction method in online applications for metal AM.